Notices
Results 1 to 3 of 3

Thread: help with pcb etching

  1. #1 help with pcb etching 
    Forum Freshman
    Join Date
    Apr 2013
    Posts
    60
    hi everyone i have attached an image of what my etched pcb looks like. Is this alright? I had the board in ferric chloride solution for an hour and then rubbed it using a kitchen sponge. Somehow this doesn't look right to me. I have also attached the schematic for the circuit i am making. Please guide me how can i properly etch the board because i tried it with another board and ended up with the same result. I don't think the copper is completely removed from the board but i am not sure how i will know if it is so help me. Thank you for your help


    Reply With Quote  
     

  2.  
     

  3. #2  
    Forum Cosmic Wizard
    Join Date
    Aug 2013
    Location
    San Diego
    Posts
    2,211
    No picture of the board was posted


    Reply With Quote  
     

  4. #3  
    Forum Freshman
    Join Date
    Apr 2013
    Posts
    60
    sorry. I can't seem to attach the picture from my computer or ipad. Thanks anyway
    Reply With Quote  
     

Similar Threads

  1. pcb drilling
    By fine in forum Electrical and Electronics
    Replies: 1
    Last Post: December 15th, 2013, 11:25 AM
  2. pcb designing
    By fine in forum Electrical and Electronics
    Replies: 5
    Last Post: October 28th, 2013, 03:45 PM
  3. using pcb software
    By fine in forum Electrical and Electronics
    Replies: 3
    Last Post: September 8th, 2013, 01:28 AM
  4. Cutting a PCB in half?
    By stander-j in forum Electrical and Electronics
    Replies: 8
    Last Post: August 12th, 2013, 05:02 PM
Bookmarks
Bookmarks
Posting Permissions
  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •